
The usual suspects
Constant running is nearly always the flush valve seal or the inlet valve. Water on the floor is either the pan connector, the cistern seal or the inlet connection, and which one it is decides whether it is a ten minute fix or a pan that needs pulling. A rocking pan usually means the fixings have worked loose, and left alone it will break the seal.
Set out checked before you buy a replacement
Old pan and cistern removed and taken away

How it works
How we find the fault and what we do about it.
Find the fault
Running, leaking or rocking each point to a different part.
Repair the part
Inlet valve, flush valve, seal or fixings, replaced with the right component.
Or replace the pan
If replacement is the call, we check the set out before anything is ordered.
Test and seal
Multiple flushes, checked for leaks, and sealed to the floor.

Why call us
A running toilet quietly costs more over a year than the repair does.
You deal with Mark, every time
The person who answers the phone is the person who quotes the job and turns up to do it. Nothing gets lost between an office and a van, and you are not explaining it twice.
Price agreed before we start
You get a fixed price up front rather than an hourly rate and a surprise at the end. Quotes are free and there is no obligation to go ahead.
Small jobs genuinely welcome
A single dripping tap is a perfectly good reason to call. If you have a list saved up we will work through it in one visit, which costs less than three separate callouts.
Plumbing
Other work we take on across the Coast and Albany.
What our customers say
Feedback from customers across the Hibiscus Coast and Albany.
FAQs
Got questions? We've answered the most common ones here.
No. Quotes are free and there is no obligation. For most jobs we can give you a realistic range over the phone once you describe what is happening. For bigger work like a cylinder replacement or a spouting run, we will come and look before quoting, because guessing helps nobody.
Most straightforward jobs land between $200 and $400. That covers things like a leaking tap, a running toilet, replacing tapware, or a blocked waste under a sink. If you have several small jobs saved up, doing them in one visit is usually cheaper than three separate callouts. You get the price before the work starts.
Search the public register on the Plumbers, Gasfitters and Drainlayers Board website. It shows whether a person holds a current practising licence and for which trades, since plumbing, gasfitting and drainlaying are registered separately. It takes a minute and it is worth doing before anyone works on your water or gas.
Yes. A single dripping tap or a running toilet is a perfectly good reason to call, and it is how most of our clients start with us. If you have saved up a list of small jobs, send it through and we will work through them in one visit, which is usually cheaper than calling someone out three separate times.
Almost always a worn flush valve seal that no longer seats, or an inlet valve that is not shutting off. Both are inexpensive parts and a short visit. It is worth fixing promptly, because a continuously running toilet is one of the largest sources of wasted water in a house and it shows up on the bill.
The cheap causes are a pressure limiting valve that has failed or been wound down, a clogged tap aerator, or a filter cartridge overdue for changing. The expensive causes are old pipework that has corroded internally, or a low pressure system that was never designed to deliver much more than it does. They are not equally costly to fix, which is why it is worth measuring before anyone quotes.
Where we work
From Whangaparāoa and Gulf Harbour through Silverdale and Orewa, out to Dairy Flat and down to Albany.
Need a plumber?
Tell us what is going on and we will give you a straight answer on price and timing.

















