
Whether your place suits one
Heat pumps need airflow and a sensible outdoor location, because they are pulling heat from the air and they make some noise doing it. Manufacturers set their own minimum clearances and those differ between suppliers, so a position that suits one brand will not always pass for another. We check the clearances for the model going in before the location is settled, rather than finding out afterwards.
Location assessed for airflow, noise and neighbours
Existing cylinder removed and disposed of

How we approach it
How we work out whether the numbers stack up for your place.
Look at your usage
How much hot water you actually use decides whether the savings stack up.
Find the location
Airflow, noise, where the condensate runs to, and how far it sits from the existing pipework.
Give you the real numbers
Install cost against likely running cost, so you can make the call yourself.
Install and commission
Fitted, connected, tested and set up, with the old cylinder taken away.

Why talk to us first
A hot water heat pump is a good buy for some households and a poor one for others.
You deal with Mark, every time
The person who answers the phone is the person who quotes the job and turns up to do it. Nothing gets lost between an office and a van, and you are not explaining it twice.
Price agreed before we start
You get a fixed price up front rather than an hourly rate and a surprise at the end. Quotes are free and there is no obligation to go ahead.
Twenty years of cylinders
Most hot water faults are an element or a thermostat rather than a dead cylinder. Knowing the difference is what stops a repair turning into a replacement you did not need.
Hot water
Other work we take on across the Coast and Albany.
What our customers say
Feedback from customers across the Hibiscus Coast and Albany.
FAQs
Got questions? We've answered the most common ones here.
A standard hot water cylinder replacement starts at around $2,700 installed, which covers the cylinder, the swap, the valves brought up to current requirements and removal of the old unit. Larger cylinders and harder access push that up. A hot water heat pump is the top of the range at up to around $6,800 installed. We confirm the price before anything is ordered, so the number you get is the number you pay.
It uses roughly a third of the electricity of a standard element cylinder, so the running cost saving is real. Whether it pays back depends on how much hot water you actually use and whether you have a sensible outdoor spot for the unit, since it needs airflow and makes some noise. For a steady, higher use household it usually stacks up. For a small household it often does not, and we will say so.
It depends on how many people are in the house, how many bathrooms you have, and whether everyone showers at the same time. As a rough guide, a couple is usually fine with a smaller cylinder, while a family of four or five with two bathrooms needs considerably more. If you currently run out of hot water most evenings, your cylinder is undersized rather than faulty.
Repair if the cylinder is sound and a component has failed, which covers most cases. Replace if it is leaking from the body, rusting at the base, or repeatedly failing at an age past twenty years. Water pooling underneath means the inner tank has corroded through and there is no repair for that. We diagnose which situation you are in before quoting either way.
Usually one of four things: a tripped breaker at the switchboard, a blown element, a failed thermostat, or a cylinder that has reached the end of its life. Check the switchboard first, because a tripped breaker is free to fix. If it trips again immediately, leave it off and call, because something is drawing a fault.
Typically fifteen to twenty five years, depending on the type, the water quality and whether it has been maintained. A cylinder in that age range that starts failing repeatedly is usually telling you it is near the end. One that is younger and has stopped heating is far more likely to have a failed element or thermostat, which is a repair rather than a replacement.
Where we work
From Whangaparāoa and Gulf Harbour through Silverdale and Orewa, out to Dairy Flat and down to Albany.
Need a plumber?
Tell us what is going on and we will give you a straight answer on price and timing.














