
Repair or replace
Traditional taps with washers can nearly always be repaired, and if the seat has worn it can be recut rather than replaced. Mixer taps use a cartridge, which is a straight swap when it fails. Either way, repairing is usually the cheaper answer.
Washers, seats and cartridges carried on the van
Advice on tapware that suits your water pressure

How it works
A short job, done properly, with the price known first.
Identify the tap
Washer type or cartridge type decides the parts and the fix.
Isolate and strip
Water isolated locally where possible so the rest of the house keeps running.
Repair or replace
New washer, recut seat or new cartridge, or new tapware if that is the call.
Test
Checked under pressure for drips at the spout and underneath.

Why call us for a dripping tap
It is a small job. That is exactly why plenty of people cannot get anyone to come.
You deal with Mark, every time
The person who answers the phone is the person who quotes the job and turns up to do it. Nothing gets lost between an office and a van, and you are not explaining it twice.
Price agreed before we start
You get a fixed price up front rather than an hourly rate and a surprise at the end. Quotes are free and there is no obligation to go ahead.
Small jobs genuinely welcome
A single dripping tap is a perfectly good reason to call. If you have a list saved up we will work through it in one visit, which costs less than three separate callouts.
Plumbing
Other work we take on across the Coast and Albany.
What our customers say
Feedback from customers across the Hibiscus Coast and Albany.
FAQs
Got questions? We've answered the most common ones here.
No. Quotes are free and there is no obligation. For most jobs we can give you a realistic range over the phone once you describe what is happening. For bigger work like a cylinder replacement or a spouting run, we will come and look before quoting, because guessing helps nobody.
Most straightforward jobs land between $200 and $400. That covers things like a leaking tap, a running toilet, replacing tapware, or a blocked waste under a sink. If you have several small jobs saved up, doing them in one visit is usually cheaper than three separate callouts. You get the price before the work starts.
Search the public register on the Plumbers, Gasfitters and Drainlayers Board website. It shows whether a person holds a current practising licence and for which trades, since plumbing, gasfitting and drainlaying are registered separately. It takes a minute and it is worth doing before anyone works on your water or gas.
Yes. A single dripping tap or a running toilet is a perfectly good reason to call, and it is how most of our clients start with us. If you have saved up a list of small jobs, send it through and we will work through them in one visit, which is usually cheaper than calling someone out three separate times.
Almost always a worn flush valve seal that no longer seats, or an inlet valve that is not shutting off. Both are inexpensive parts and a short visit. It is worth fixing promptly, because a continuously running toilet is one of the largest sources of wasted water in a house and it shows up on the bill.
The cheap causes are a pressure limiting valve that has failed or been wound down, a clogged tap aerator, or a filter cartridge overdue for changing. The expensive causes are old pipework that has corroded internally, or a low pressure system that was never designed to deliver much more than it does. They are not equally costly to fix, which is why it is worth measuring before anyone quotes.
Where we work
From Whangaparāoa and Gulf Harbour through Silverdale and Orewa, out to Dairy Flat and down to Albany.
Need a plumber?
Tell us what is going on and we will give you a straight answer on price and timing.

















