
The five parts that usually fail
The element heats the water and is the most common failure. The thermostat tells the element when to run, and when it fails you get either no hot water or water that is dangerously hot. Both are inexpensive parts on a cylinder that has years left in it.
Common parts carried on the van
Tempering valve checked so the water is safe as well as hot

How a repair runs
How we work out whether it is worth repairing at all.
Confirm power and controls
Breaker, isolator and thermostat, before we touch anything else.
Test the element
A quick test says whether the element has gone open circuit.
Check the valves
TPR, tempering and cold water expansion valves, since all three affect what comes out of the tap and what runs to waste.
Replace and test
Part replaced, cylinder brought back up to temperature, and outlet temperature checked.

Why repair with us
Most cylinders that stop working are not finished. They have a failed part.
You deal with Mark, every time
The person who answers the phone is the person who quotes the job and turns up to do it. Nothing gets lost between an office and a van, and you are not explaining it twice.
Price agreed before we start
You get a fixed price up front rather than an hourly rate and a surprise at the end. Quotes are free and there is no obligation to go ahead.
Twenty years of cylinders
Most hot water faults are an element or a thermostat rather than a dead cylinder. Knowing the difference is what stops a repair turning into a replacement you did not need.
Hot water
Other work we take on across the Coast and Albany.
What our customers say
Feedback from customers across the Hibiscus Coast and Albany.
FAQs
Got questions? We've answered the most common ones here.
A standard hot water cylinder replacement starts at around $2,700 installed, which covers the cylinder, the swap, the valves brought up to current requirements and removal of the old unit. Larger cylinders and harder access push that up. A hot water heat pump is the top of the range at up to around $6,800 installed. We confirm the price before anything is ordered, so the number you get is the number you pay.
It uses roughly a third of the electricity of a standard element cylinder, so the running cost saving is real. Whether it pays back depends on how much hot water you actually use and whether you have a sensible outdoor spot for the unit, since it needs airflow and makes some noise. For a steady, higher use household it usually stacks up. For a small household it often does not, and we will say so.
It depends on how many people are in the house, how many bathrooms you have, and whether everyone showers at the same time. As a rough guide, a couple is usually fine with a smaller cylinder, while a family of four or five with two bathrooms needs considerably more. If you currently run out of hot water most evenings, your cylinder is undersized rather than faulty.
Repair if the cylinder is sound and a component has failed, which covers most cases. Replace if it is leaking from the body, rusting at the base, or repeatedly failing at an age past twenty years. Water pooling underneath means the inner tank has corroded through and there is no repair for that. We diagnose which situation you are in before quoting either way.
Usually one of four things: a tripped breaker at the switchboard, a blown element, a failed thermostat, or a cylinder that has reached the end of its life. Check the switchboard first, because a tripped breaker is free to fix. If it trips again immediately, leave it off and call, because something is drawing a fault.
Typically fifteen to twenty five years, depending on the type, the water quality and whether it has been maintained. A cylinder in that age range that starts failing repeatedly is usually telling you it is near the end. One that is younger and has stopped heating is far more likely to have a failed element or thermostat, which is a repair rather than a replacement.
Where we work
From Whangaparāoa and Gulf Harbour through Silverdale and Orewa, out to Dairy Flat and down to Albany.
Need a plumber?
Tell us what is going on and we will give you a straight answer on price and timing.














